Franke SLIM45 Manual De Instalación Y Servicio página 13

Air switch operated
Disposer Air Switch Assembly
The Actuator which consists of:
1. Actuator Button
2. Actuator Nut
3. Actuator Outlet (threaded portion)
The Air Switch Sensor Enclosure which is
installed into the disposer. Only the air tube
nozzle is visible from the outside of the
disposer.
Air Tube Assembly which consists of:
4. Air Tube - clear or black
5. Air Tube Nut
5
Operating instructions
Your disposer is Continuous Feed if you did not
specifically purchase a Batch Feed Disposer.
Continuous feed
The Anti-Jam Swivel Impellers make a clicking
sound as they initially swing into place. This
indicates normal operation.
1. Remove sink stopper. Turn on a medium
flow of cold water.
2. Turn switch to ON position; your motor will
be turning at full speed and ready to use.
3. Scrape in food waste. Down the drain go
table scraps, peelings, rinds, seeds, pits,
small bones and coffee grounds. To speed
up food waste disposal, cut or break up large
bones, rinds and cobs. Large bones and
fibrous husks require considerable grinding
SLIM45 / SLIM50 / SLIM75 / SLIM75BF / SLIM100 / SLIM125
1
2
3
4
5
Installation and operating instructions
1. If a hole does not already exist - drill a hole of
35 mm to 40 mm into the sink or countertop
where the actuator button (1) is to be placed.
2. Insert, from the top, the actuator outlet
through the drilled hole.
3. Thread the actuator nut (2) onto the actuator
outlet (3) and tighten firmly by hand.
4. Firmly connect air tube: one side to actuator
outlet (3) and one side to sensor inlet.
5. Plug disposer power cord into main
electrical service.
6. To turn on disposer, press actuator button (1).
To turn off, press actuator button again.
Suggestions
Be sure disposer is empty before using your
dishwasher so it may drain properly.
You may want to leave the stopper in the sink
drain when not in use to prevent utensils and
foreign objects from falling into the disposer.
Your disposer is sturdily built to give you
many years of trouble free service. It will
handle all normal food wastes, but it will not
grind or dispose of such items as plastic, tin
cans, bottle caps, glass, china, leather, cloth,
rubber, string, clam and oyster shells,
aluminum foil or feathers.
time and are more easily thrown away with
other trash. Do not be alarmed that the
disposer slows down while grinding. The
disposer is actually increasing torque
(grinding power) and is operating under
normal conditions.
4. Before turning disposer off, let water and
disposer run for approximately 15 seconds
after shredding stops. This assures that all
waste is thoroughly flushed through trap and
drain.
5. It is not recommended to use hot water
while running disposer. Cold water will keep
waste and fats solid so disposer can flush
away particles.
Batch feed
13
EN