Franke SLIM45 Manual De Instalación Y Servicio página 15

Troubleshooting
Before seeking repair or replacement, we
recommend that you review the following:
Loud noises (other than those during grinding
of small bones and fruit pips): these are usually
caused by accidental entry of a spoon, bottle
cap or other foreign object.
To correct this, turn off electrical switch and
water. After disposer has stopped, remove
splash guard, remove object with long
handled tongs and reinstall splash guard.
Unit does not start:
1. Unplug power cord or turn either the wall
switch or breaker box switch to "OFF"
position, depending on your model and
wiring configuration.
2. Remove stopper and /or splash guard.
Check to see if turntable will rotate freely
using a wooden broom handle. If turntable
rotates freely, replace splash guard and
check reset button to see if it has been
tripped. Reset button is red and located
opposite discharge elbow, near the bottom
(fig. 3). Push button in until it clicks and
remains depressed.
3. If reset button has not been tripped, check
for shorted or broken wire connecting to
disposer. Check electrical power switch,
fuse box or circuit breaker. If wiring and
electrical components are intact, the unit
may have internal problems that require
service or replacement.
Cleaning and maintenance
Do not attempt to lubricate your disposer!
The motor is permanently lubricated. The
disposer is self cleaning and scours its internal
parts with each use. Never put caustic soda or
chemical drain cleaners, as hydrochloric and
muriatic acid, products for unclogging the sink
drain, into the disposer, as they cause serious
corrosion of metal parts. If used, resulting
SLIM45 / SLIM50 / SLIM75 / SLIM75BF / SLIM100 / SLIM125
If turntable does not rotate freely:
1. Turn off disposer, then check for any foreign
object lodged between the turntable and
grind ring.
2. Dislodge object by rotating table with a
wooden broom handle and remove object
(fig. 7). If no foreign object is present, there
may be internal problems.
7
Leaks: If the unit leaks at the top, it may be due to:
– Improper seating of sink flange (gasket
centering, putty or tightening).
– Support ring not tightened properly.
– Defective or improperly installed cushion
mount.
If unit leaks at the waste elbow, leak may be due
to improper tightening of elbow flange screws.
damage can be easily detected and all
warranties are void. Mineral deposits from your
water can form on the stainless steel turntable,
giving the appearance of rust. Do not be
alarmed, the stainless steel turntables used will
not corrode.
15
EN
Remove
splash guard
Turntable