Publicidad
Idiomas disponibles
Idiomas disponibles
How to Wire Your Ceiling Fan (Continued)
BLACK
L
WHITE
N
RED
L1
AC
POWER
3.
Connect wires using connectors as shown in
Figure 4. Connect the 2 pin connectors from the motor
assembly to the 2 pin connectors from the receiver,
connect the 3 pin connectors from the motor assembly
to the 3 pin connectors from the receiver.
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors. Do not operate fan until the blades are
in place. Noise and motor damage could result.
4.
After connections have been made, put the white
and green leads to one side and the black leads
towards the other side, the connection should be
turned upward and carefully push leads into the outlet
box. The wires should be spread apart with the
grounded conductor and the equipment-grounding
conductor on one side of the outlet box and the
ungrounded conductor on the other side. (Figure 5)
WARNING
The blades must be installed first before programming
is performed.
Receptacle connector from receiver
GROUND
HANGER
BRACKET
HANGER
BALL
RF ANTENNA
BLUE
BROWN
RECEIVER
Figure 4
CAUTION: INCORRECT WIRE CONNECTION
COULD DAMAGE THIS RECEIVER.
RECEIVER HARDWARE USED:
Wire Connectors
Green Wire
from Supply
(Ground)
Green Wire
from Hanger
Bracket (Ground)
Green Wire
from Receiver (2)
(Ground)
Green Wire
from Hanger
Ball (Ground)
11
Plug connector from motor
BLUE
BROWN
YELLOW
GRAY
RED
DC MOTOR
WHITE
LIGHT KIT
X
4
White Wire
Listed
from Supply
Outlet Box
Black Wire
from Supply
White Wire
from Receiver
Red Wire
from Supply
Receiver
Black Wire
from Receiver
Figure 5
BLUE
Household
Supply
Publicidad
