Publicidad
Idiomas disponibles
Idiomas disponibles
How to Assemble Your Ceiling Fan
1.
Remove the three stabilizer tabs and plastic bag
from the motor assembly. Discard the stabilizer tabs.
(Figure 1)
2.
Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in
the hanger ball until the ball falls freely down the
downrod. Remove the pin from the downrod, then
remove the hanger ball. Retain the pin and hanger
ball for reinstallation in Step 7. (Figure 2)
3.
Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 5. (Figure 3)
4.
Loosen the two set screws and locking nuts in the
downrod support of the motor assembly. Route the
wires through the downrod. (Figure 4)
Motor
Assembly
Downrod
Hanger Ball
Hairpin Clip
Set Screws and
Locking Nuts (2)
7
Stabilizer
Tabs
Figure 1
Pin
Set Screw
Figure 2
Clevis Pin
Figure 3
Wires
Downrod
Figure 4
Publicidad
