Publicidad
Step 13
1
D20
K
Groove
Insert the DRAWER SIDES (D20 and D21) at an angle
å
into the slot at each end of the DRAWER FRONT (K).
3
Fasten the DRAWER BACK (D74) to the DRAWER SIDES (D20
å
and D21). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D716) inserts into the
å
groove of the DRAWER BACK (D74).
Page 18
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D21
D74
D20
D716
VIEW THE T-LOCK BOX VIDEO
2
D20
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D716) into the grooves in the
å
DRAWER SIDES (D20 and D21) and DRAWER FRONT (K).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D21
411204
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n
fi n
s u
i s h
r f a
e d
c e
D716
D21
K
30S
(4 used in this step)
www.sauder.com/services
Publicidad
