Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 3 INSTALL HOOD CANOPY
TO THE CABINET
1. Tuck the house wiring out of the way.
2. Push the hood canopy straight up through the
cutout opening until the temporary locking clips
engage. The locking clips are designed to hold
the insert sleeve in place until it is secured with
screws.
NOTE: The locking clips are
not designed to support all
of the weight of the insert
sleeve. Do not leave the
insert sleeve unattended
until screws have been
installed.
16
Installation - UVC 9420
Clip
2x4 Stud
STEP 4 INSTALL DAMPER
1. Seal the duct to the damper with duct tape. (DO
NOT USE SCREWS)
2. Install the damper into the bottom of the exhaust
fan opening using 2 screws provided (D).
a. Check to make sure the damper opens freely.
b. Tighten the 2 screws (D).
Screws
49-2000930 Rev. 2
Publicidad
