Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
PROBLEM
The handle is
not in position.
The product does not
start.
The product cuts grass
unevenly.
The mower is hard
to push.
The product does not
mulch correctly.
The product is hard to
push.
There is a high vibration
in the product.
The product stops during
mowing.
POSSIBLE CAUSE
The bolts are not engaged cor-
rectly.
The battery capacity is low.
The start handle is defective.
The battery key is not put in.
The lawn is rough.
The blade height is not set
correctly.
The grass is too tall, or the cutting
height is too low.
The rear of the mower housing
and the blade are dragging in
thick grass.
Wet grass clippings attach to the
deck.
The mulch plug is missing.
The grass is too tall, or the blade
height is too low.
The grass catcher and the blade
drags in thick grass.
The blade is unbalanced and
worn.
The motor shaft is bent.
The blade height is too low.
The battery pack is out of power.
The grass clippings attach to the
deck or the blade.
Operation temperature of the
product is too high.
CORRECTIVE ACTION
Adjust the height of the handle and
make sure that the bolts and nuts are
aligned correctly.
Charge the battery pack.
Replace the start handle.
Put in the battery key.
Examine the mowing area.
Move the wheels to a higher position.
Raise the cutting height.
Empty the grass clippings from the
grass catcher bag.
Wait until the grass dries before
mowing.
Install the mulch plug.
Increase the blade height.
Empty the grass clippings from the
grass catcher.
Replace the blade.
1. Stop the motor.
2. Remove the safety key and battery
pack.
3. Disconnect the power source.
4. Inspect for damage.
5. Pepair the product before you start
it again.
Increase the blade height.
Charge the battery pack.
Remove the battery pack and check
the deck.
Cool the product.
22
Publicidad
