ASSEMBLY INSTRUCTIONS
1. Installing the upper handle
•
Raise the upper handle so that the mounting
holes align with the holes on the lower
.
handle
•
Insert the quick-release clamps (BB) and
securely tighten the handle knobs (AA) on the
opposite ends.
Hardware Used
AA
Handle knob
BB
Quick-release clamp
2. Adjusting the handle position
•
Pull the lower handle (H) to the operation
position.
•
Secure the handles in one of the two positions
by aligning the handlebars with the mounting
holes at the base of shafts.
•
Insert the bolts (CC) through the handles
.
and the bracket
knobs (AA) onto the bolts.
Note: Make sure that the two handles are in the
same position.
Hardware Used
AA
Handle knob
CC
Bolt
Securely tighten the handle
1
x 2
x 2
2
H
x 2
x 2
12
BB
AA
AA
CC