Publicidad
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS MANUAL
3. The smoke output flow can also be programmed in manual mode. You can choose between 50%, 80%
and 100%. To do this, repeatedly press the menu button (13) until the "Fog Volume" option appears on
the first line of the LCD screen. The second line indicates the chosen flow rate. You can modify it with
the + (14) and – (15) buttons and confirm your choice with the "ENTER" button (16). If you do not confirm
your choice, the change will not be saved. To return to the main screen, press the "MENU" key (13) again
or wait 15 seconds without pressing any button.
4. To activate GEYSER with the programmed parameters, make sure you are on the main screen and
press the "VOLUME" key (15).
5. To stop the output of the machine, press the "STOP" button (16).
*In manual operation mode it is possible to program a cycle of timed shots. To do this, press and hold
the "MENU" key (13) for three seconds to access the advanced menu. Once you are in the advanced
menu, press the menu button (13) repeatedly until the "Interval Set" option appears on the first line of
the LCD screen. The second line indicates the wait time between shots or interval (in seconds). You can
modify it with the + (14) and – (15) buttons and confirm your choice with the "ENTER" button (16). If you
do not confirm your choice, the change will not be saved.
To define the shooting time, and staying within the advanced menu, repeatedly press the
menu button (13) until the "Duration Set" option appears on the first line of the LCD screen. The second
line indicates the trigger time between intervals (in seconds). You can modify it with the + (14) and – (15)
buttons and confirm your choice with the "ENTER" button (16). If you do not confirm your choice, the
change will not be saved. To return to the main screen, press and hold the "MENU" key (13) again for
three seconds or wait 15 seconds without pressing any button.
Once these fields have been defined, you can activate the timed release by pressing the "TIMER" button
(14) on the main screen. To stop the shooting cycle press the "STOP" key (16).
CONFIGURATION AND CONTROL BY DMX
When connecting the machine via DMX, the manual operation functions are disabled.
You can check if GEYSER is receiving DMX signal. On the main screen, the two lit dots at the end of "DMX
Add:" will flash. If they are fixed it means that the machine is not receiving a DMX signal.
1. Select the DMX address of the machine. To do this, repeatedly press the menu button (13) until the
"Set DMX Address" option appears on the first line of the LCD screen. The second line indicates the cho-
sen DMX address. You can change the DMX address with the + (14) and – (15) buttons and confirm your
choice with the "ENTER" button (16). If you do not confirm your choice, the change will not be saved. To
return to the main screen press the "MENU" key (13) again or wait 15 seconds without pressing any but-
ton.
2. GEYSER can be controlled by DMX in three different modes: 1 channel, 11 channels and 14 channels.
To change modes, press the menu button (13) repeatedly until the "Channel Mode" option appears on
the first line of the LCD screen. The second line indicates the chosen mode. You can change the mode
with the + (14) and – (15) buttons and confirm your choice with the "ENTER" button (16). If you do not con-
firm your choice, the change will not be saved. To return to the main screen, press the "MENU" key (13)
again or wait 15 seconds without pressing any button.
4
Publicidad
