Publicidad
Step 3
å
Fasten the TOP MOLDING (M27) to the TOP (E). Use
three BLACK 1-1/8" PAN HEAD SCREWS (Q).
å
NOTE: You should start each SCREW a few turns before
completely tightening them. Do not overtighten.
å
Push three HOLE PLUGS (O) into the holes in the
TOP MOLDING.
å
Slide the END MOLDINGS (G) onto the notched
edges of the ENDS (A and B) until they are against
the TOP MOLDING.
Slide the END
MOLDINGS
onto the ENDS.
G
Page 6
Notched edge
B
G
414237
Q
BLACK 1-1/8" PAN HEAD SCREW
(3 used in this step)
Do not overtighten
the SCREWS (Q).
M27
E
O
A
www.sauder.com/service
Publicidad
