Maytag NEPTUNE Guia Del Usuario página 6

[IIONTROLS AT
A GLANCE
Step
Sensor Dry - automatically senses the moisture in the load
and shuts the dryer off when the selected dryness level (very
dry to damp dry) is reached.This cycle is recommended for the
majority of loads including delicates, wrinkle free and
cotton/sturdy items like towels, bedding and jeans.
Or
Time Dry - may be selected for any load if Sensor Dry is not
used. Press the "+" or "-" time pad to select the desired number
of minutes.
Step
DryTemp - there are four temperature settings. Press the up
"_'_." or down "..J" pads to select regular, medium, delicate or
extra low temperatures.
Regular - for sturdy cottons or those labeled "Tumble Dry."
Nedium - for permanent press, synthetics, lightweight cot-
tons or items labeled "Tumble Dry Nedium:'
Delicate - for heat sensitive items labeled "Tumble Dry
Low" or "Tumble DryWarm;'
Extra Low - provides the lowest heated dry temperature
possible."Extra LowTemperature" is lower than "Delicate."
DryTemp
Step
Select Dryness Level - press the "/_o" or " _o\" arrow pads
to select the desired dryness level.The dryness level can be set
on or between a setting.
Very Dry - used to completely dry sturdy or bulky items
including towels and jeans.
wrink!eprevent
codi d own
Normal - used for drying the majority of loads.
Damp Dry - designed to partially dry items. Used for items
that lay fiat or hang to dry.
normal
Step
Setting the Signal - the end of cycle signal is adjustable. Press
the "+" or "-" signal pad to increase or decrease the volume of
the signal.
5