Publicidad
Idiomas disponibles
Idiomas disponibles
42", 50" & 54" Stamped Deck Striper Kit - Model
19A70060OEM
Model 19A70060OEM striper kit is designed for use with
select Residential Zero Turn (RZT) mowers. Refer to your RZT's
Operator's Manual to assure compatibility.
Carton Contents - Model 19A70060OEM
Before beginning installation, remove all parts from the carton
to make sure everything is present. Carton contents are listed
below. Part numbers are shown in parentheses. See Figure 1-4.
1.
Four Carriage Bolts, 5/16-18 x 1.00 (710-0276)
2.
One Roller Pin, 1/2 x 27.75 (711-05664)
3.
Four Lock Nuts, 5/16-18 (712-04063)
4.
One Lock Nut, 1/2-13 (712-3083)
5.
Four Rollers (731-05679B)
6.
One Left Roller Bracket (789-02377)
7.
One Right Roller Bracket (789-02378)
5
4
S
2 — i
ection
nStallation
2
1
3
7
Figure 1-4
42" Stamped Deck Striper Kit Installation - Model
19A70060OEM
To install the Striper Kit on tractors equipped with a 42" stamped
deck proceed as follows:
1.
Use Figure 1-5 below to locate the proper mounting hole
locations on the Left and Right Roller Brackets (#6 & #7) for
your kit.
Figure 1-5
2.
Install the Left and Right Roller Brackets (#6 & #7) to the
locations shown in Figure 1-6 on the Tractors deck with two
Carriage Bolts (#1) and two 5/16 Lock Nuts (#3) per side.
Figure 1-6
3.
Align the four Rollers (#5) inside the brackets and slide the
Roller Pin (#2) through the center of the rollers and into the
mounting hole of the Right Roller Bracket (#7). See Figure
1-7.
Publicidad
