Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Make sure that the J-shaped end on the Roller Pin is
secured in the mounting hole of the Left Roller Bracket (#6)
and then secure the end on the Roller Pin with a 1/2 Lock Nut
(#4). See Figure 1-7.
Figure 1-7
5.
The roller can be adjusted to two different heights. To
change the height of the striper kit, remove the Locknut
and slide the pin out far enough to move it into the desired
height setting on the right side of the bracket. Secure the
hooked end of the pin and install the lock nut to lock into
position. See Figure 1-8.
Figure 1-8
NOTE: Deck wheels may need adjusted for maximum
striping performance. See your Tractors Operator Manual
for instructions on adjusting the deck wheels.
50" & 54" Stamped Deck Striper Kit Installation -
Model 19A70060OEM
To install the Striper Kit on Tractors equipped with a 50" or 54"
stamped deck proceed as follows:
1.
Use Figure 1-9 below to locate the proper mounting hole
locations on Left and Right Roller Brackets (#6 & #7) for
your kit.
Figure 1-9
2.
Install the Left and Right Roller Brackets (#6 & #7) to the
location shown in Figure 1-10 on the Tractors deck with two
Carriage Bolts (#1) and two 5/16 Lock Nuts (#3) per side. See
Figure 1-10.
Figure 1-10
S
2 — i
ection
nStallation
5
Publicidad
