IBEA Ares Manual De Usuario página 28

-We recommend biodegradable chain lubricating oil above 85%, with
viscosity 100 measured at 40° (ASTM D445 method)
-NB: use only clean and non-recycled oil to fill the tank. Waste oil can
damage the lubrication pump.
CHECK THE TENSION OF THE CHAIN
Attention!!!! Before each operation it is necessary to ALWAYS check that the
chain is tensioned and not loose.
- Make sure the machine is turned off and the battery disconnected.
- If you have just used the machine, wait a few minutes for it to cool before
proceeding with the voltage adjustment.
- Loosen the protective cover of the bar (image 1).
- Wearing protective gloves, try to move the chain using a link in the lower
part of the bar; if the tension is correct you should see the guide teeth of the
link halfway up, pulling the link downwards.
- If the chain is too tight, it can be adjusted using the screw positioned
on the side opposite the front protective casing of the machine. Turning
counterclockwise will loosen the chain. (image 2)
- If it is loose, use the screw located on the front of the machine to tighten it.
Turning the screw clockwise will tighten the chain.
- Tighten the protective casing and proceed with starting the machine
(image 3).
- With the tool tightened, the link must come halfway out of the chain bar.
1
2 3
3.2 Preparation for use
Before proceeding with use:
1. Fully charge the batteries;
2. Insert the battery into the designated slot;
3. Remove the bar cover;
4. Press and hold the power button until the display turns on. The machine
will emit two sounds, the first starting and the second to indicate that the
machine is ready for work.
5. The machine is equipped with a safety button to be pressed at the same
time as the chain link start trigger. Once started, release the safety button.
28