Publicidad
Idiomas disponibles
Idiomas disponibles
BATTERY TEST RESULT
Battery test result includes 5 types as following:
Status >60%
Voltage >12.4V
Status >60%
Voltage <12.4V
Status <60%
Voltage >12.4V
Status <60%
Voltage <12.4V
Voltage <12.4V,
Status = 0
Electric current: 0A or 0 CCA
1. GOOD BATTERY
Status: 96%
490CCA
Charge: 98%
12.64V
Internal R =
6.1mΩ
Rated: 500A
Good battery
3. REPLACE
Status: 46%
490CCA
Charge: 8 0%
12.68V
Internal R =
18.1mΩ
Rated: 500A
Replace
5. CHARGE, RETEST
Status: 39%
310CCA
Charge: 20%
12.08V
Internal R =
30.1mΩ
Rated: 500A
Charge, retest
CRANKING TEST
Cranking test is the Engine ignition test. This test allows to check if
the battery can provide enough power to start the engine. It tests the
battery instant voltage once start the engine. If cranking voltage value
is lower than 9.6V, the result is considered as abnormal. If the result is
higher than 9.6V, the result is considered as normal.
CHARGING TEST (ALTERNATOR TEST)
1. Charging Test result: Normal
Charging system shows the generator output voltage. If the result is
normal, no problem detected.
2. Charging Test result: Low
Charging voltage of the charging system is low.
Check drive belt of the generator whether slip or running off.
Check the connection between generator and battery is normal or not.
www.fulbat.com
Good battery
Good, recharge
Replace
Charge, retest
Bad cell, replace
2. GOOD, RECHARGE
Status: 78%
440CCA
Charge: 30%
12.20V
Internal R =
7.2mΩ
Rated: 500A
Good, recharge
4. BAD CELL, REPLACE
Status: 0%
0CCA
Charge: 20%
10.64V
Internal R =
45.2mΩ
Rated: 500A
Bad cell, replace
If both of the drive belt and the connection are in good condition, follow
the manufacturer's suggestion to eliminate generator fault.
3. Charging test result: High
Generator output voltage is high. Since most of the vehicle generators
are using internal regulator, the generator assembly has to be replaced.
(Some old style cars are using external regulator, then directly replace
the regulator.).
The normal high volt of the voltage regulator is maximum 14.7±0.5V. If
charging volt is too high, it will overcharge the battery. Therefore the
battery life will be shortened and troubles will be caused.
4. No Voltage Output:
No generator voltage output is detected. Check the generator connection
cable and the belt whether they are normal.
5. Diode Test:
Through the test of charging current ripple, tester will find out whether
the diode is normal or not. When ripple volt is too high, it proves at least
one diode is damaged. Check and replace the diode.
REVIEW DATA
Choose the function of Review Data and review the history of battery
testing result.
Status: 96%
Charge: 98%
Internal R=
Rated: 500A CCA
PRINT DATA
Choose the function of Print and press ENTER.
Before choose the print data function, it is necessary to connect the
battery tester to the computer via USB cable.
Once all are available, please install the print program on your computer.
1. Install the USB driver firstly:
2. Then open the Print software.
4
490A
12.64V
6.3mΩ
Good battery
DOWNLOAD
DRIVER
Publicidad
