Publicidad
Idiomas disponibles
Idiomas disponibles
4. Install casters into basket and feet by inserting the caster stems into the holes
provided. Apply pressure and twisting motion until casters snap into place.
5. If flat washers are included in hardware package place flat washer over stem of
caster before installing casters into feet or basket. NOTE: Flat washers are not
required with all units.
If your caster basket looks like the one shown to the right, assemble as follows.
1. With cord disconnected from receptacle and tank cover removed, turn tank upside
down so that the bottom is facing up.
2. Take basket and place into slots (on rear of tank opposite of drain). Secure with
screws provided.
3. With tank drain facing you, take caster foot marked with the letter A and place
in slot on left side of tank also marked with the letter A. Secure with screw
provided.
4. Take caster foot marked with the letter B and place in slot on right side of tank
also marked with the letter B. Secure with screw provided.
5. If flat washers are included in hardware package place flat washer over stem of caster before installing
casters into feet or basket. NOTE: Flat washers are not required with all units.
6. Install casters into caster feet and basket by inserting the
caster stems into the holes provided. Apply pressure and
twisting motion until caster snap into place.
PLASTIC TANK WITH REAR CASTER DOLLY
You will find four casters, two caster feet, one dolly and four screws with your wet/dry vacuum.
Some units come with an accessory basket. This is not standard on all models.
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down so
that the bottom is facing up.
2. Take rear caster dolly and place into slots (on rear of tank, opposite of drain
and secure with screws provided.
PAGE 6
ASSEMBLY (CONT'D.)
Caster
Foot
Caster
Caster
Foot
Screw
Screw
Caster
Foot
Publicidad
