Tognana IRIDEA D2DFU01IRRO Manual De Usuario página 20

HAZARD! Do not place in the dishwasher or submerge in
liquids.
IMPORTANT NOTE
or abrasive detergents for cleaning.
3. Storage
•
When the appliance is not being used, the power cord must be wound up in its dedicated
housing under the power base.
•
Check that all the parts are clean and dry before putting them away.
•
Never stow the appliance while it is still wet.
•
It is recommended to store the appliance in a dry, clean place far from moisture and dust.
TROUBLESHOOTING
PROBLEM
The appliance is not working.
The motor unit gives off a strong odour the
first few times the appliance is used.
The PULSE function is not working.
During operation there is a lot of noise, a
strong smell or the motor body becomes
very hot.
The problem is not solved.
INFORMATION ON DISPOSAL
ITEM
Pursuant to Art. 26 of Legislative Decree No. 49 of 14 March 2014 "Implementation of Directive
2012/19/EU on waste electrical and electronic equipment (WEEE)", the crossed-out bin symbol
indicates that this appliance is not to be considered municipal waste. Disposing of it must
therefore be carried out by separate waste collection. Failure to dispose of the appliance as
separate waste may constitute a potential hazard to the environment and human health. Said
product can be returned to the distributor upon purchase of a new appliance.
Improper disposal of the appliance constitutes fraudulent conduct and is subject to sanctions by the
Police Authority. For further information, contact the local administration responsible for
environmental management.
PACKAGING
For information on how to correctly dispose of the packaging used to protect this product and its parts
and/or accessories, follow the instructions in the packaging.
: do not use chemical detergents, steel wool
The appliance has two safety systems. It will not
work if the blender's carafe has not been properly
inserted on the motor unit, or if the lid has not been
properly inserted on the carafe. Turn the appliance
off and check for correct assembly.
This is normal. This is due to the manufacturing
residue burning. If the odour persists, check that the
blender is not overloaded.
To prevent accidental activation, the PULSE
function only works when the blender is turned on
via the speed control.
Turn the appliance off immediately and contact the
authorised service centre.
Contact an authorised service centre.
SOLUTION
20