Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROLS
Seat Adjustment
The seat can be adjusted lengthways with the
lever located at the right hand side of the seat.
When making adjustments the lever is moved
upward.
Adjustments may be made to seat suspension by
turning the center knob.
IMPORTANT INFORMATION
be adjusted while unit is in motion.
Seat Release
The seat can be rotated forward to access the
mower battery and hydro gears. Push down on
the latch lever to release the seat. Raise the seat
until the rod engages.
Fuses
Fuses are located on the left hand side of the
machine and are accessed by tilting the seat
forward. Fuses are flat pin fuses type as used in
automobiles. The 20 A is the primary fuse. The
7.5 A is for the mower deck coupling. The 10 A is
for accessories.
Seat must not
Cutting Height
The cutting height pedals release the deck lift and
set the desired deck height. Apply pressure to
the lift pedal (lower) and rotate foot to also apply
pressure to the release pedal (upper), unlocking
the deck lift.
For transport, push the lift pedal forward until the
deck lift latches in the transport (highest) position.
The cutting height can be set from 1"- 5" (25.4
mm - 127 mm. To set the deck cutting height,
press the button on the top of the height pin to
remove it. Slip the height pin into the hole for the
desired cutting height.
Release deck height control pedal by pushing it
forward.
IMPORTANT INFORMATION Always raise the
deck to the highest position for transport.
Fuel Tanks
Read the safety instructions before refueling. The
capacity for each tank is 6 gallons (22.7 liters).
Regularly check the gas cap gasket for damage
and keep the cap properly tightened.
WARNING! Fill to bottom of filler neck.
Do not overfill. Wipe off spilled oil or fuel. Do
not store, spill or use gasoline near an open
flame.
The engine will run on a minimum of 87-octane
unleaded gasoline (no oil mix). Environmentally
adapted alkylate gasoline can be used. See
15
Publicidad
