Mercedes-Benz Foster MB WHP 1 Manual Del Usuario página 39

Adjusting the headphones
38
Adjusting the headphones
The length of the headband can be adjusted to
ensure the best fit for the headphones.
Hold the headband of the headphones and
X
pull the earpieces until the headband is at
the required length.
The earpieces can be turned 90° outwards to
store the headphones.
Establishing a connection between
the headphones and the end device
The headphones can be connected to the
end device either via Bluetooth
AUX cable supplied.
®
! A Bluetooth
established if the AUX cable is not
inserted into the headphones and there is
no active Bluetooth
the headphones and an end device.
®
Bluetooth
Trademarks
®
Bluetooth is a registered brand of the
Bluetooth Special Interest Group (SIG) Inc.
M+P-03F-9745
®
or with the
connection can only be
®
connection between
Technical requirement
The end device to be connected must
®
support Bluetooth version 4.2 or higher.
! Make sure that the distance between the
end device and headphones is not
greater than 3 m.
General notes
Up to eight end devices can be stored in the
®
Bluetooth memory of the headphones. Two
presets are reserved for Rear Entertainment
Systems. If more end devices are connected,
then the oldest connection is replaced by the
new one.
It is possible to connect two end devices
simultaneously with the headphones via
®
Bluetooth . Audio files can be played back
on one end device while the headphones are
used as a hands-free system for both end
devices.
i
In order to switch from using one end
device as an audio source, you must first
stop audio playback and then start it on
the desired end device.
Establishing a Bluetooth
manually
To switch on the headphones: press and
X
hold the button for 2 seconds.
Press the button twice.
X
The headphones are ready to be
connected.
Switch on the end device and activate
X
®
Bluetooth ; see the manufacturer's
instructions.
A list of the available Bluetooth
appears.
„MB Headphone" must now be selected
X
from the list.
®
A Bluetooth connection between the
headphones and the device is established.
®
connection
®
devices