Mercedes-Benz Foster MB WHP 1 Manual Del Usuario página 46

Declarations of conformity
Wireless components
The following observations are valid for all
wireless components of the Mercedes-Benz
®
Bluetooth headphones:
The wireless components of this device
comply with the basic requirements and all
other relevant provisions of Directive 2014/
53/EC. You can obtain further information
from any Mercedes-Benz Service Centre.
Electromagnetic compatibility
The electromagnetic compatibility of the
Mercedes-Benz Bluetooth
tested and proven in accordance with the
ECE-R 10 regulation, in the respective
current version.
FCC
This device complies with part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
FCC CAUTION Changes or modifications not
expressly approved by the party responsible
for compliance could void the user's
authority to operate the equipment
Properly shielded and grounded cables and
connectors must be used for connection to
host computers and / or peripherals in order
to meet FCC emission limits.
Note: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
®
headphones was
Declarations of conformity
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
^
Increase the separation between the
^
equipment and receiver.
Connect the equipment into an outlet on a
^
circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced
^
radio/TV technician for help.
This transmitter must not be co-located or
operated in conjunction with any other
antenna or transmitter.
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment and meets the FCC radio
frequency (RF) Exposure Guidelines as this
equipment has very low levels of RF energy.
45