Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Working safely with this machine is
posible only when the operating and safety
information are read completely and the
instructions contained therein are strictly
followed.
• Do not make structural changes to the equipment
• The trolley jack is only for lifting Not for supporting the
load. Working on or under lifted vehicles is allowed only
after placing axle stands with correct capacity in the
correct places. The vehicle should be secured against
tipping over, rolling away or sliding off and supported
with blocks.
• The trolley jack may be used only on level and firm
surfaces.
Art.-No.
Type
Lifting force
Height min. / max.
Weight
Quick lift
Hydraulic oil:
References
A
Handle for moving and jacking
B
Knurled screw
C
Foot pedal
D
Support plate
E
Lifting arm
Mounting
Loosen the knurled screw B on the side of the forkhandle.
holder somewhat. Insert the handle A and tighten the
knurled screw until it engages in the slot of the handle. The
handle must be capable of being pulled out by approx. 2
cm and turned.
Operation
Handle functions
Pull and turn
Pump without pulling =
6
For your safety
Specifications
0715 54 100
RHC-2
2000 kg
80/500 mm
36 kg
Castrol Hyspin AWS 22 / Shell Tellus HLP - HM 22/ BP HLP 22 / Esso Univis N 22 /
=
Lowering
Lifting
• The distance to walls, doors and firm structures must be
more than 0.5 m to allow for escaping in case of danger.
• The vehicle should not be lifted when damage to the
vehicle could result from fuel, battery acid or other
harmful fluids.
• Lift the vehicle only at lifting points recommended by the
manufacturer.
• When malfunctions occur, do not operate the trolley jack.
• During lifting, persons are not allowed to remain in the
vehicle.
0715 54 140
RHC-2H
2000 kg
98/735 mm
53 kg
Mobil DTE 22 / Elfona DS 22 / Fina Hydran LZ 22
Positioning the lifting arm E to working
height
• Operate the foot pedal C for quick approach unloaded.
• Pump with maximum stroke to bring the support plate D
quickly to the working height.
Lifting of loads
• The best performance is achieved with short pump-
strokes. Ensure that the support plate is correctly
positioned.
• For vehicles that are too heavy, the overload valve
opens and lifting is not possible.
Do not continue to pump when the trolley jack is at
the highest position.
Lowering
• Pull the handle and turn to the right to open the lowering
valve; the lowering speed can be regulated with the
angle of turning.
0715 54 150
0715 54 160
RH-4
4000 kg
145/560 mm
150/570 mm
70 kg
RH-6
6000 kg
90 kg
Publicidad
