Publicidad
Idiomas disponibles
Idiomas disponibles
Malfunctions
• The vehicle cannot be lifted because the lowering valve
does not close:
Loosen the locking nut from the nut (128) by lightly strik-
ing with a plastic hammer, if necessary, and read just the
play (0.5 - 1.5 mm).
During the adjustment, the spindle should not be turned.
• The vehicle cannot be lifted high enough: Check the oil
level as described under maintenance.
Maintenance
Monthly
• Lubricate the mechanical parts with acid-free oil and
check for damage.
• Check the oil level:
Remove the cover plate. Remove the plug screw (15) on
the top of the pump unit. With lowered lifting arm, the oil
level must be 10 mm under the filler opening.
Use only recommended hydraulic oil, not brake fluid
or motor oil.
Quarterly
• Remove the circlip rings on the wheels as well as the
casters, pull off the wheels and lubricate the ball bear-
ings with acid-free grease.
After several years of use
• Replace the seals as necessary. Use only original Würth
parts.
Contact our customer service when your unit does not
operate correctly in spite of having followed the instructions
give above. You will be helped quickly and reliably.
Designation / Description
Cast wheels with rubber covering, 1 set (4 wheels)
• For protecting the workshop floor.
Pneumatic rubber wheels, 1 set (2 wheels)
• Makes possible easy transport and maneuverability.
• Wheel must not be dismounted during the lifting process.
Saddle pillow
• Protects the vehicle.
• Made of oil-resistant rubber material.
Axle traverse
• Lifting force 1200 kg., min. width 750 mm., max. width 1080 mm.
• For lifting of front-drive vehicles that have no front traverse.
• Makes quick changing of wheels possible.
Accessories (not included with the equipment)
Subject to change without notice
Warranty
For this Würth tool, we provide a warranty in accordance
with statutory/country-specific regulations from the date of
purchase (proof of purchase by invoice or delivery note).
Damage that has occurred will be corrected by replace-
ment or repair.
Damage caused by normal wear, overloading or improper
handling is excluded from the warranty.
Claims can be recognized only when the tool is presented
undisassembled to a Würth branch office or a Würth field
service employee.
Declaration of Conformity
We declare under our sole responsibility that these
products are in conformity with the following standards or
standardisation documents:
RICHTLINIE 2006/42/EG DES EUROPÄISCHEN PARLA-
MENTS UND DES RATES
Adolf Würth GmbH & Co. KG
P. Zürn
R. Bauer
Typ
Art.-Nr
RHC-2,
0715 54 165
RHC-2H
RH-4,
0715 54 15
RH-6
RHC-2,
0715 54 170
RHC-2H
RHC-2,
0715 54 14
RHC-2H
Pieces
1
7
Publicidad
