Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Pre-set programmes with quick pre-heat
Some pre-set programmes require the oven to
be pre-heated. They are marked accordingly
in the above table. When you select a pre-set
programme with pre-heating and touch
confirm, the quick pre-heat
be displayed. When the set temperature is
reached, you will hear beeping, which will turn
off when you open the oven door. Place the
food in the oven and close the door, at which
point the actual pre-set programme will start.
Note: It is inadvisable to modify a pre-set
programme during the quick pre-heat phase
as this will cancel pre-set programme and the
appliance will operate with the currently set
function, duration and temperature.
End a pre-set programme.
When a pre-set programme ends, you will
hear beeping.
Oven door
Oven door must be closed during operation.
When you open the door you will interrupt the
active oven function. If the door remains open
for more than 30 seconds, an acoustic signal
will sound to prompt you to close the oven
door. Touch any sensor or close the oven door
to mute the beeping.
If you open the door for less than 10 minutes
the active settings are unaffected. For safety
reasons, after this time, the oven enters the
standby mode (all settings are cleared).
Limit the oven operating time
For safety reasons, the oven operation is time
limited. If the set temperature is up to 100°C,
the oven will enter Standby mode after 10
hours, and if the set temperature is 200°C and
more, the oven operation is limited to 3 hours.
In the temperature range of 101°C to 199°C,
the operation time is limited proportionally
between 3 and 10 hours.
Quick pre-heat
to
pictogram will
In order to quickly pre-heat the oven, the fan,
fan heater and the roaster are on, and the
appliance operates at it maximum power of
3.6 kW.
The OpenUp! function
This function allows you to open the oven
door by touching the handle. There are two
opening modes to choose from – One time
touch the handle to open the door once only
when the oven is on. In Always mode you can
always touch the handle to open the door
when the oven is on.
IMPORTANT: The OpenUp! function does
not work when the oven is turned off (in
stand-by mode, when the clock indicates the
current time).
To activate the OpenUp! function when the
oven operates, touch and hold the
the
and the previous pictogram will be replaced
with
To open the oven door, touch the metal strip
of the oven door handle. You need to touch
the handle for at least 0.5 second. The sen-
sitivity of the handle allows you to open the
door with your hand or a covered part of the
body, e.g. the elbow or the knee.
Regardless of the OpenUp! settings, the
door can be opened manually in any situa-
tion by pulling the handle.
and Always
. In On-time mode you can
simultaneously, and the display will show
pictogram. Touch
.
and
and
again
51
Publicidad
