LaserLiner Quadrum Compact Manual Del Usuario página 29

If points A2 and A3 are more than 0.15 mm / m apart on either
!
the X or Y axis, the device is in need of adjustment. Contact your
authorised dealer or else the UMAREX-LASERLINER Service Department.
Adjustment mode
Take the alignment of the rotary laser into account when performing
adjustment work.
Switch on the device. Switching off the tilt function.
X axis adjustment
Activate adjustment mode: Press the ON/OFF button for 3 seconds
until the auto/man LED flashes.
Adjustment: Use the positioning buttons of the remote control to
move the laser from its current position to the height of reference
point A2. Keep pressing the positioning buttons at second intervals
until the required position is reached.
Cancel adjustment: Switch the device off.
Saving: To save the new adjustment, press the ON/OFF button
again for 3 seconds.
Adjust the Y and Z axes
To adjust the Y-axis, use the X/Y button on the remote control
to switch to the Y-axis and proceed in the same way as for
adjusting the X-axis.
To adjust the Z axis, set up the device vertically
and proceed in the same manner as for the
X axis adjustment.
Regularly check the adjustment before
!
use, after transport and after extended
periods of storage. Always make sure to
control all axes.
Quadrum Compact / Compact Green
Z
Y
X
29
EN