Braun Sensation 7 Manual Del Usuario página 5

How to use your Braun Sensian™ 7
Note: The thermometer and Individual should be in the same ambient temperature for at
least 10 minutes.
1. Remove protective cap
2. Power on
Press and release the power button once . Backlight will
come on and the start-up sequence begins .
NOTE: Make sure to remove the protective scanner cap
before taking a measurement .
3. Select age range
Select age with Age Precision™ Technology button .
Device will start cycling through the age ranges, highlighting the 3 ranges
you may select: 0-3 months ( ), 3-36 months (
Press the Age Precision™ Technology button to toggle through the age
ranges until you select the age appropriate for the individual .
3 .1 To set a preferred age range: (Locking an age setting)
To save a preferred age range, so that it will be automatically selected when
the thermometer is turned ON, follow these steps:
A . Make sure the thermometer is OFF .
B . Press and hold the power button ( ) and Age Precision™ Technology
button ( ) for 4 seconds . The unit will turn on, displaying a yellow
backlight and the 3 age range icons will flash .
C . Press the Age Precision™ Technology (
will flash . Press the Age Precision™ button until your desired age range is
flashing on the display .
D . Once the desired age range is selected, stop pressing the button and wait
3 seconds . The green backlight will illuminate, and the selected age range
will turn solid . After 4 seconds, the thermometer will turn off .
E . The preferred age range will be automatically selected when the thermometer is turned ON .
Note: With a preferred age range, an alternate age range can be selected during each use, by pressing
the Age Precision™ button when the age range icon appears, after the thermometer is turned ON .
6
), or 36+ months ( ) .
) button . The age range selected
F . To remove the preferred age range, open the battery door, remove the batteries, wait 30
seconds and re-insert the batteries .
IMPORTANT: To ensure accurate readings, you must always take a temperature reading in the
age range that corresponds to the individual's age .
4. Position correctly with PositionCheck™
Position thermometer on or up to 2 .5 cm away from
the center of the forehead, just between the eyebrows .
When the thermometer is ready and on or 2 .5 cm away
from the forehead a horizontal line of dashes ("---") will
appear on the screen .
For non-contact readings, the yellow aiming light will
show you where you are aiming .
If the eyebrow area is covered with hair, sweat or dirt,
please clean the area beforehand to improve the reading
accuracy . It is important to hold the thermometer and
the forehead steady during measurement . Movement
will impact the temperature reading .
5. Take temperature
Three dashed lines mean the thermometer is ready to
take a temperature . Press the temperature button . The
display will show a dashed line animation while it takes
a reading . Once the reading is complete a confirmation
beep will be heard and the appropriate fever light color
will be displayed on screen .
If the device is positioned too far away from the forehead, it will prompt you
to move closer by displaying the characters "0-2 cm" . Slowly move the
device toward the forehead until the dashed line animation starts and a
reading is displayed .
English
0-2.5 cm
7