Braun Sensation 7 Manual Del Usuario página 7

Changing the sound mode
The Braun Sensian™ 7 thermometer allows you to silence the
beeps on the thermometer to avoid waking a sleeping child . To
activate the silence feature, slide the switch to the silent mode
position and take a temperature reading . An icon will appear on
the screen to indicate that the thermometer is in silent mode .
Calibration
This product has been calibrated at the time of manufacture . If used according to the use
instructions, periodic calibration is not required . This device is not intended as a substitute for
regular check-ups by your doctor, please consult your doctor if you have any doubt about the
temperature reading .
Errors and troubleshooting
Error message Situation
When 20% of battery life is left, the
display flashes the low battery warning
symbol; however, the device can still work
until the battery life has 0% left .
If the steady battery icon is the only
symbol shown on the display, the device
cannot work . The battery should be
replaced immediately .
This message displays when the
measured temperature is lower than
34 °C (93 .2 °F) or higher than 43 °C
(109 .4 °F) or when the room temperature
is outside the operating range of
15 °C – 40 °C (59 °F – 104 °F) .
10
Solution
Replace batteries .
Replace batteries .
Re-measure the temperature,
carefully following the
instructions in "How to use"
section .
System error – self-check display flashes
continuously and will not be followed by
the ready beep and the ready symbol .
If error persists,
If error still persists,
Blank display . Thermometer does not
have power .
Care and cleaning
Use an alcohol swab or cotton swab moistened with alcohol (70% isopropyl) to clean the
thermometer casing and the measuring probe . Ensure that no liquid enters the interior of the
thermometer . Never use abrasive cleaning agents, thinners or benzene for cleaning and never
immerse the instrument in water or other cleaning liquids . Wait 10 minutes after cleaning before
taking a temperature measurement . Make sure to replace the protective cap after use to prevent
scratches or damage from occurring to the thermometer .
Never insert a sharp object into the scanner area or any other open surface on the thermometer .
Replacing the batteries
The Braun Sensian™ 7 thermometer comes with 2 AAA batteries . Replace with 2 new AAA batteries
when the flashing battery symbol appears on the LCD screen . To change the batteries, slide open
the battery cover and remove batteries . Replace the batteries being sure to align properly as
indicated inside the battery compartment . Remove the battery from the product if it is not required
for extended periods of time in order to avoid damage to the thermometer resulting from a leaking
battery .
Remove the battery from the instrument if it is not required for extended periods of time in order to
avoid damage to the thermometer resulting from a leaking battery .
Only discard empty batteries . They should not be disposed of in the household waste, but
at appropriate collection sites or at your retailer .
2 Year Limited warranty
Please read all instructions before attempting to use this device . Please retain the receipt as proof
of and date of purchase . The receipt must be presented when making any claim within the relevant
guarantee period . Any claim under the guarantee will not be valid without a proof of purchase .
Your device is guaranteed for Two Years (2 Years) from date of purchase .
English
Wait 1 minute until the
thermometer turns off
automatically, then turn on
again .
. . . reset the thermometer by
removing the batteries and
putting them back in .
... please contact Customer
Service .
Please check if the batteries
have been loaded correctly .
Also check polarity (<+> and
<–>) of batteries .
Contact customer service if
thermometer still does not
function .
11