Polygroup SUMMER WAVES RX1000 Manual Del Usuario página 16

ROTOR INSPECTION AND REPLACEMENT INSTRUCTIONS
1. To replace the Rotor Assembly 23
sure that it has all of its parts and that the center shaft, magnetic axle, or impeller blades are not broken as this will cause the pump to fail. If your rotor assembly is
broken, a complete rotor assembly may be purchased at polygroupstore.com without having to replace the whole pump.
Please see Pool Support - Filtration System Troubleshooting for the SFX Filtration System at support.polygroupstore.com.
PLEASE NOTE: Even if the rotor assembly is in perfect condition if it is not seated properly between the volute cover and the pump it will not function correctly.
RX600/RX1000
Once the rotor assembly has been checked or if replacing with a new rotor assembly, slowly insert the rotor assembly back down into the pump carefully.
2.
The force of the magnet will pull the rotor assembly into the pump.
Align the Shaft properly and fasten the Volute Cover
3.
4. Attach the Rubber Nozzle 18
PUMP REPLACEMENT INSTRUCTIONS
1.
Lubricate the Canister Gasket
Insert it into the groove on the bottom of
the Canister .
2.
Please make sure the cord has been placed through the
Pump Base before replacing Pump
slowly insert the Pump Motor Assembly
the Canister .
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
16
, remove the Volute Cover 24 and pull out the Rotor Assembly
25
Rotor Assembly Parts
24
23
22
24 with the Volute Cover Lock Nut
to the outlet of Motor Assembly. To complete assembly, proceed to "Pump Replacement Instructions" below.
Step 1.
and
. Then
back into
MST. Extended operating days and hours during peak season requirements.
23 from the Pump Body 22
RX1500
25 or with the Volute Cover Bolt and Nut Set
Step 2.
15
. Inspect the rotor assembly to make
26
24
23
22
26 .
Cord