Polygroup SUMMER WAVES RX1000 Manual Del Usuario página 17

3. Once the Pump is inserted into the Canister
canister and make sure that the Rubber Nozzle
with the notch on the canister (visible from bottom only). Please make sure that the pump is correctly aligned, if it is not aligned correctly the Pump Base
can still lock in place but may leak.
BOTTOM VIEW OF PUMP AND CANISTER
4. Once the Pump is properly aligned, be sure the Gasket
carefully tighten the Pump Base
leaking out of the bottom of the canister.
5. To lock the Pump Base , apply the latch pin by turning to the right.
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
17
, please make sure the arrow with the indentation is pointing to the matching indentation on the
is aligned with the water Outlet on the Canister. There is a groove on the pump that needs to be aligned
Step 3.
Close Up
17
onto the threads by turning clockwise. Make sure the pump base is not cross threaded. Cross threading can cause
15
19
17
MST. Extended operating days and hours during peak season requirements.
TOP VIEW OF PUMP AND CANISTER
Make sure that the notch and groove are aligned.
The water outlet on Canister
and the Rubber Nozzle
the pump should be aligned.
is properly in place. Then slide the Pump Base
Step 4.
Step 5.
OWNER'S MANUAL
on
up to the base of the canister and
17
17
19 19
15
19