EINHELL TE-RH 950/1 5F Manual De Instrucciones Original página 16

5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
Check the drilling point for concealed electrical
cables, gas and water pipes using a cable/pipe
detector.
5.1 Additional handle (Fig. 2 – Item 6)
For safety reasons you must only use the
hammer drill with the additional handle.
The additional handle (6) enables you to achieve
better stability whilst using the hammer drill. The
machine must not be used without the additional
handle (6) for safety reasons.
The additional handle (6) is secured to the
hammer drill by a clamp. Turning the handle anti-
clockwise (looking from the handle) will release
the clamp. Turning the handle clockwise will tigh-
ten the clamp.
First release the additional handle clamp. You can
then swing the additional handle (6) into the most
comfortable working position for you. Now turn
the additional handle in the opposite direction
again until the additional handle is secure.
5.2 Fitting and adjusting the depth stop (Fig.
3/Item 7)
The depth stop (7) is held in place by the additio-
nal handle (6) by clamping.
•
Release the locking screw (a) and insert the
depth stop (7).
•
Set the depth stop (7) to the same level as
the drill bit.
•
Pull the depth stop back by the required dril-
ling depth.
•
Retighten the locking screw (a).
•
Now drill the hole until the depth stop (7) tou-
ches the workpiece.
5.3 Changing the drill chuck (Fig. 4)
You can choose between the quick-change drill
chuck (11) and the SDS-Plus drill chuck (1).
Warning:
Always pull out the power plug before making ad-
justments to the equipment.
Anl_TE_RH_950_1_5F_SPK13.indb 16 Anl_TE_RH_950_1_5F_SPK13.indb 16
GB
Fitting:
•
Pull back and hold the locking sleeve (2).
•
Turn and push the dust-free drill chuck into
the mount.
•
Allow the locking sleeve (2) to slide back to its
starting position again.
•
Check the lock by pulling the drill chuck.
Removing:
•
Pull back and hold the locking sleeve (2).
•
Remove the drill chuck.
5.4 Inserting the tool (Fig. 5-6)
Warning:
Always pull out the power plug before making ad-
justments to the equipment.
Note:
Release the depth stop as described in 5.2 and
push it towards the additional handle. This provi-
des free access to the chuck.
5.4.1 Quick-change drill chuck (Fig. 5 / Item
11)
•
Open the chuck (11). The drill bit opening
must be large enough to hold the drill bit.
•
Select a suitable drill bit. Push the drill bit as
far as possible into the chuck opening.
•
Close the chuck (11). Check that the drill bit is
secure in the chuck (11).
•
Check at regular intervals that the drill bit or
tool is secure.
5.4.2 SDS-Plus drill chuck (Fig. 6 / Item 1)
•
Clean the tool before fitting it and apply a thin
coating of bit grease to the tool shaft.
•
Turn and push the dust-free tool into the tool
mounting as far as it will go. The tool will lock
automatically.
•
Check that the bit is locked in placed by
pulling on it.
To remove it, pull back and hold the locking slee-
ve (b) and remove the tool.
- 16 -
14.10.2021 08:38:55 14.10.2021 08:38:55