Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting the compressed air hose without a valve adapter
Screw the free end of the compressed air hose
„
item.
Connecting the compressed air hose with a valve adapter
The valve adapters
„
(see Fig. B).
First screw the required valve adapter
„
Then insert the valve adapter
„
remove the valve cap of the inflatable item).
Removing the compressed air hose
Connecting without the valve adapters
„
the valve of the inflatable item.
Connecting with the valve adapters
„
valve on the inflatable item. Unscrew the valve adapter
(if necessary, reattach the valve cap on to the inflatable item).
PLEASE NOTE: When disconnecting the compressed air hose
of the inflatable item. Ensure that you remove the compressed air hose
Pressure-Preselect function
Switch on the power bank with compressor
„
Connect the compressed air hose
„
which you want to inflate. To do so, please proceed as described in the previous section.
Use the "M" menu button
„
("bar"), kilopascal ("KPa"), kilogram per square centimetre ("KG/CM²") and pound per square inch
("PSI") (see Fig. E).
Use the "+" button
„
you can keep the respective button pressed down. Pressure settings between 0.3 bar and 3.5 bar
are possible in 0.05 bar steps (see Fig. E).
PLEASE NOTE: While preselecting the pressure, the digital pressure gauge with the air pressure
and battery display will flash
display the ACTUAL value of the pressure. The pressure which has been set remains stored.
Switch on the integrated compressor by pressing the On/Off button for the compressor
„
The compressor will start and pump up the inflatable item.
„
You can switch off the compressor at any time by pressing the On/Off button for the compressor
„
once more.
Otherwise, the compressor will switch off automatically once the inflatable item has reached the
„
preset pressure.
Disconnect the inflatable item from the compressed air hose
„
At the end of work, screw the compressed air hose
„
bank with compressor
ATTENTION: The hose connection
Make sure that you do not come into contact with the hose connection
suffering burns. At the end of work, wait for at least 10 minutes before you unscrew the compressed air
hose
back off the hose connection
17
PLEASE NOTE: After switching on the power bank with compressor
switch
, the device switches off automatically after approximately 20 seconds if the compressor
9
is not started or if no consumables are connected.
,
and
are located in the storage compartment for the valve adapters
21
22
23
,
21
,
or
into the connection valve of the inflatable item (if necessary
21
22
23
,
21
,
21
22
of the power bank with compressor
17
to select the desired unit of pressure. The units available are bar
5
and the "-" button
3
4
. If a button is not pressed for at least 10 seconds, the display will
6
.
1
of the power bank with compressor
15
of the power bank with compressor
15
directly on to the connection valve of the inflatable
17
or
to the free end of the compressed air hose
23
22
or
: Unscrew the compressed connection hose
22
23
or
: First, pull the valve adapter off the connecting
23
,
or
21
22
23
by using the switch for the power bank
1
to select the desired pressure. To speed up the selection,
as described in the previous section.
17
back off the hose connection
17
off the compressed air hose
, air can escape from the valve
17
as quickly as possible.
17
9
to the inflatable item
1
of the power
15
heats up during operation.
1
during operation to avoid
15
.
1
with the power bank
1
GB/IE/NI/CY/MT
14
.
17
off
17
17
.
once.
2
2
15
Publicidad
