Publicidad
Idiomas disponibles
Idiomas disponibles
PLEASE NOTE: The digital pressure gauge with air pressure and battery display
bank with compressor
up, in which incorrect pressure can be dangerous (e.g. tyres), find a specialist unit with a
trade-approved device and check the pressure of the inflatable item.
Tips for use
The device is not intended for continuous operation. The device was designed to create air pressure –
not an air flow. Please do not use the device for more than 7 minutes at a time on items with a large
volume, to avoid overheating and damage to the device. Then let the device cool down for at least 15 minutes.
We recommend first filling a large-volume item with air, in order to then generate the required pressure
with the device. Do not use the device for more than 7 minutes at a time without stopping. Then let the
device cool down for at least 15 minutes.
Air pressure testing with the power bank with compressor
PLEASE NOTE: The digital pressure gauge with air pressure and battery display
bank with compressor
Switch on the power bank with compressor
„
Connect the inflatable item to the compressed air hose
„
whose pressure you want to check. To do so, please proceed as described in the section "Connecting
the compressed air hose with a valve adapter" or "Connecting the compressed air hose without a
valve adapter".
Use the "M" menu button
„
("bar"), kilopascal ("KPa"), kilogram per square centimetre ("KG/CM²") and pound per square inch
("PSI") (see Fig. E).
The digital pressure gauge with air pressure and battery display
„
connected inflatable item in the preset unit.
Disconnect the inflatable item from the compressed air hose
„
. To do so, please proceed as described in the section "Removing the compressed air hose".
1
PLEASE NOTE: When disconnecting the compressed air hose
of the inflatable item. Ensure that you remove the compressed air hose
Safety fuse
If the device becomes overloaded or malfunctions, the safety fuse triggers to protect the device.
Never use a fuse with a higher release current strength. There is a risk of fire!
Attention: To protect people and property, an overheat protection circuit has been installed
for the rechargeable battery pack in the power bank with compressor
overheating of the rechargeable battery pack installed in the device and automatically switches off the
power bank with compressor
to cool down prior to re-commissioning it.
z Switching the lighting on
Lighting mode
To switch the LED light
„
Press the power switch for the LED light
„
16
GB/IE/NI/CY/MT
is not trade-approved. Therefore, if inflatable items have been pumped
1
is not trade-approved.
1
1
to select the desired unit of pressure. The units available are bar
5
if the battery temperature is too high. If this happens, allow the device
1
on, press the power switch
7
three times to switch the LED light
7a
by using the switch for the power bank
of the power bank with compressor
17
shows the pressure of the
6
of the power bank with compressor
17
, air can escape from the valve
17
for the LED light.
7a
of the power
6
of the power
6
.
9
1
as quickly as possible.
17
. This prevents an
1
off again.
7
,
Publicidad
