Publicidad
Idiomas disponibles
Idiomas disponibles
Flash mode
To switch the LED light
„
The LED light
will then be permanently lit.
7
Briefly press the power switch for the LED light
„
mode.
Briefly press the power switch for the LED light
„
mode. There will be 3 short flashes, 3 long flashes and another 3 short flashes.
Briefly press the power switch
„
CAUTION! Do not look directly at the LED light
PLEASE NOTE: It is not possible to turn on the light while the power bank with compressor
charging.
z Using the jumpstart feature
When using the jumpstart, make sure that at least 3 bars are permanently illuminated on the battery
level indicator
.
13
1
Step
LEDs
1. Connect the jump
Red Error LED
lead
of the power
18
lead
bank with compressor
A short alarm will sound once
to the vehicle
1
a second.
jumpstart outlet
of
8
the power bank with
Green Start LED
compressor
.
1
2. First connect the
Red Error LED
red clamp (A) to the
lead
positive pole of the
A short alarm will sound twice
vehicle battery and
a second.
then connect the black
Red Error LED
battery clamp (B) to
lead
the negative pole
An alarm will sound several
(see Fig. 1).
times a second in quick
succession.
Green Start LED
permanently lit.
Once the green Start LED
has remained permanently lit
for more than 90 seconds, then
the red Error LED
Start LED
permanently lit.
on in flash or SOS mode, press the power switch
7
for the LED light once again to switch off the LED light
7a
B
A
2.
1.
on the jump
20
is permanently lit.
18
flashes.
19
on the jump
20
is permanently lit.
18
on the jump
20
is permanently lit.
18
is
19
19
and green
20
will be
12
once again and the LED light
7a
once again and the LED light
7a
as this can damage your eyes.
7
Meaning / Error
The voltage determined in the
power bank with compressor
is not enough to start the
1
car.
Power bank with compressor
ready.
1
Battery clips (A) and (B) are
the wrong way round.
A short circuit has occurred or
the battery is leaking.
The connection is correct.
The connection is correct,
however because the vehicle
was not started within
90 seconds, the jumpstart
procedure was stopped for
safety reasons.
GB/IE/NI/CY/MT
for the LED light.
7a
will switch to flash
7
will switch to SOS
7
.
7
Solution
Charge the power bank with
compressor
.
1
Carry on with step 2
Disconnect the black battery
clip (B) first and then the red clip
(A) from the battery poles.
Start again from step 1.
Carry on with step 3.
Disconnect the black battery
clip (B) first and then the red clip
(A) from the battery poles.
Start again from step 1.
is
1
17
Publicidad
