Ferm OTM1001 Traducción Del Manual Original página 6

- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns
DESCRIPTION (fIg. A)
Your multitool has been designed for light
sanding, sawing and scraping applications.
1. On/off switch
2. Speed adjustment wheel
3. Mounting point for accessories
4. Grip
5. Allen key
6. Allen key holder
ASSEMBLy
4
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Mounting and removing the sanding pad and
the sanding paper (fig. B)
The sanding pad and the sanding paper must be
used for sanding applications.
Mounting
● Place the machine on a table with the mounting
point (3) facing upwards.
● Loosen the Allen screw (7) using the Allen key
(5).
● Mount the sanding pad (9) to the mounting
point (3).
● Tighten the Allen screw (7) using the Allen key
(5).
● Mount sanding paper (10) with the required
grain size onto the sanding pad (9). Make sure
that the perforation in the sanding paper (10)
corresponds with the perforation on the sanding
pad (9).
- Use coarse sanding paper (grain 50) for
sanding rough, uneven surfaces.
- Use medium sanding paper (grain 80) for
removing the remaining scratches from the
coarse sanding paper.
- Use fine sanding paper (grain 120) for
finishing surfaces.
6
removing
● Place the machine on a table with the mounting
point (3) facing upwards.
● Remove the sanding paper (10) from the
sanding pad (9).
● Loosen the Allen screw (7) using the Allen key
(5).
● Remove the sanding pad (9) from the mounting
point (3).
● Tighten the Allen screw (7) using the Allen key
(5).
Mounting and removing the saw blade (fig. B)
The saw blade must be used for sawing
applications.
Mounting
● Place the machine on a table with the mounting
point (3) facing upwards.
● Loosen the Allen screw (7) using the Allen key
(5).
● Remove the spacer (8).
● Mount the saw blade (11) to the mounting point
(3).
● Mount the spacer (8).
● Tighten the Allen screw (7) using the Allen key
(5).
removing
● Place the machine on a table with the mounting
point (3) facing upwards.
● Loosen the Allen screw (7) using the Allen key
(5).
● Remove the spacer (8).
● Remove the saw blade (11) from the mounting
point (3).
● Mount the spacer (8).
● Tighten the Allen screw (7) using the Allen key
(5).
Mounting and removing the scraping knife
(fig. B)
The scraping knife must be used for scraping
applications.
Mounting
● Place the machine on a table with the mounting
point (3) facing upwards.
● Loosen the Allen screw (7) using the Allen key
(5).
● Remove the spacer (8).
● Mount the scraping knife (12) to the mounting
point (3).
● Mount the spacer (8).
● Tighten the Allen screw (7) using the Allen key
(5).