Slope Operation - MTD A Serie Manual Del Operador

Slope Operation

Slopes are a major factor related to slip and
fall accidents, which can result in severe injury.
Operation on slopes requires extra caution. The
machine is heavy and can speed up when going
downhill. Be prepared to maintain control of
the machine. If you feel uneasy on a slope, do
not mow it. For your safety, use the slope gauge
included as part of this manual to measure
slopes before operating this machine on a
sloped or hilly area. If the slope is greater than 15
degrees, do not mow it.
Do:
1. Mow across the face of slopes; never up
and down to avoid loss of control.
2. Exercise extreme caution when changing
direction on slopes; turn uphill not down.
3. Watch for holes, ruts, rocks, hidden
objects, or bumps which can cause you to
slip or trip. Tall grass can hide obstacles.
4. Always be sure of your footing. A slip
and fall can cause serious personal
injury. If you feel you are losing your
balance, release the blade control handle
immediately and the blade will stop
rotating within three (3) seconds.
Do Not:
1. Do not mow near drop-offs, ditches
or embankments, you could lose your
footing or balance.
2. Do not mow slopes greater than 15
degrees as shown on the slope gauge.
3. Do not mow on wet grass. Unstable
footing could cause slipping.
Children
Tragic accidents can occur if the operator is not
alert to the presence of children. Children are
often attracted to the mower and the mowing
activity. They do not understand the dangers.
Never assume that children will remain where
you last saw them.
1. Keep children out of the mowing area and
under watchful care of a responsible adult
other than the operator.
2. Be alert and turn mower off if a child
enters the area.
3. Before and while moving backwards, look
behind and down for small children.
4. Use extreme care when approaching blind
corners, doorways, shrubs, trees, or other
objects that may obscure your vision of a
child who may run into the mower.
5. Keep children away from hot or running
engines. They can suffer burns from a hot
muffler.
6. Never allow children under 14 years of
age to operate this machine. Children 14
and over should read and understand the
instructions and safe operation practices
in this manual and on the machine and be
trained and supervised by an adult.
7. After stopping engine, remove Electric
Start Push Key (if equipped) and keep it in
a safe place out of the reach of children.
Service
Safe Handling Of Gasoline:
1. To avoid personal injury or property
damage use extreme care in handling
gasoline. Gasoline is extremely flammable
and the vapors are explosive. Serious
personal injury can occur when gasoline is
spilled on yourself or your clothes, which
can ignite. Wash your skin and change
clothes immediately.
2. Use only an approved gasoline container.
3. Never fill containers inside a vehicle or on
a truck or trailer bed with a plastic liner.
Always place containers on the ground
away from your vehicle before filling.
4. Remove gas-powered equipment from the
truck or trailer and refuel it on the ground.
If this is not possible, then refuel such
equipment on a trailer with a portable
container, rather than from a gasoline
dispenser nozzle.
5. Keep the nozzle in contact with the rim of
the fuel tank or container opening at all
times until fueling is complete. Do not use
a nozzle lock-open device.
6. Extinguish all cigarettes, cigars, pipes and
other sources
of ignition.
7. Never fuel machine indoors because
flammable vapors will accumulate in the
area.
8. Never remove gas cap or add fuel while
engine is hot or running. Allow engine to
cool at least two minutes before refueling.
9. Never over fill fuel tank. Fill tank to no
more than 1 inch below bottom of filler
neck to provide for fuel expansion.
10. Replace gasoline cap and tighten securely.
11. If gasoline is spilled, wipe it off the engine
and equipment. Move machine to another
area. Wait 5 minutes before starting
engine.
12. Never store the machine or fuel container
near an open flame, spark or pilot light as
on a water heater, space heater, furnace,
clothes dryer or other gas appliances.
13. To reduce fire hazard, keep machine free
of grass, leaves, or other debris build-up.
Clean up oil or fuel spillage and remove
any fuel soaked debris.
14. Allow machine to cool at least 5 minutes
before storing.
General Service:
1. Never run an engine indoors or in a poorly
ventilated area. Engine exhaust contains
carbon monoxide, an odorless and deadly
gas.
2. Before cleaning, repairing, or inspecting,
make certain the blade and all moving
parts have stopped. Disconnect the spark
plug wire and ground against the engine
and remove Electric Start Push Key (if
equipped) to prevent unintended starting.
3. Check the blade and engine mounting
bolts at frequent intervals for proper
tightness. Also, visually inspect blade
for damage (e.g., bent, cracked, worn).
Replace blade with the original equipment
manufacture's (O.E.M.) blade only, listed
in this manual. "Use of parts which
do not meet the original equipment
specifications may lead to improper
performance and compromise safety!"
4. Mower blades are sharp and can cut. Wrap
the blade or wear gloves, and use extra
caution when servicing them.
5. Keep all nuts, bolts, and screws tight to
be sure the equipment is in safe working
condition.
6. Never tamper with safety devices. Check
their proper operation regularly.
7. After striking a foreign object, stop
the engine, disconnect the spark plug
wire and ground against the engine.
Thoroughly inspect the mower for any
damage. Repair the damage before
starting and operating the mower.
8. Never attempt to make a wheel or cutting
height adjustment while the engine is
running.
9. Grass catcher components, discharge
cover, and trail shield are subject to wear
and damage which could expose moving
parts or allow objects to be thrown.
For safety protection, frequently check
components and replace immediately
with original equipment manufacturer's
(O.E.M.) parts only, listed in this manual.
"Use of parts which do not meet the
original equipment specifications may
lead to improper performance and
compromise safety!"
10. Do not change the engine's governor
setting or over-speed the engine. The
governor controls the maximum safe
operating speed of the engine.
11. Check fuel line, tank, cap, and fittings
frequently for cracks or leaks. Replace if
necessary.
12. Do not crank engine with spark plug
removed.
13. Maintain or replace safety and instruction
labels, as necessary.
14. Observe proper disposal laws and
regulations. Improper disposal of fluids
and materials can harm the environment.
15. According to the Consumer Products
Safety Commission (CPSC) and the U.S.
Environmental Protection Agency (EPA),
this product has an Average Useful Life of
seven (7) years, or 140 hours of operation.
At the end of the Average Useful Life
have the machine inspected annually by
an authorized service dealer to ensure
that all mechanical and safety systems
are working properly and not worn
excessively. Failure to do so can result in
accidents, injuries or death.
S 1 — i S o
ection mportant afe
p 3
peration racticeS