Publicidad
Idiomas disponibles
Idiomas disponibles
10
„ Insert the diamond cutting disc into the dust extraction hood from below. Pay
attention to the direction of rotation of the cutting disc; the arrows on the dust
extraction hood and cutting disc must point in the same direction.
11
„ Press and hold the locking button.
„ Fasten the cutting disc by tightening the clamping nut with a flange key for de-
pressed-centre angle grinder wheels. The flat side of the clamping nut must
face the cutting disc.
12
„ Let go of the locking button, slide the base plate onto the dust extraction hood,
and tighten the wing screw.
13
„ Fit the suction hose to the connection piece of the dust extraction hood.
14
„ To process scratch-sensitive materials, place the shoe on the base plate.
14
Publicidad
