Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Safety is an obligation of the owner. Periodic inspection,
adjustment and lubrication will keep your generator in
the safest and most efficient condition possible. The most
important points of generator inspection and lubrication are
explained on the following pages.
WARNING
If you are not familiar with maintenance
work, have a franchised dealer do it for safety.
Item
Spark plug
Fuel
Check fuel hose for cracks or damage, Replace if necessary.
Fuel hose
Oil
Air filter
Muffler screen
Spark arrester
Fuel filter
Crankcase breather hose
Check hose weather for cracks or damage. Replace if necessary.
Cylinder head
Decarbonizes cylinder head more frequently if necessary.
Valve clearance
Check all fittings and fasteners. Correct if necessary.
Fittings / fasteners
The point where abnormality was recognized by use
(1) Initial replacement of the engine oil is after before one month or after 20 hours of operation.
(2) The air filter needs to be cleaned more frequently when using in unusually wet or dusty areas.
T
Since these items require tools, date and technical skills, you should find a local dealer perform the service.
Spark plug inspection
Standard spark plug:
BPR6ES/BP6ES ( NGK)
F7RTC/F7TC
Spark plug gap: 0.6-0.7mm
Routine
Check condition. Clean and replace if necessary.
Check fuel level and leakage.
Check oil level in engine.
Replace.
Check condition. Clean.
Check condition. Clean and replace if necessary.
Check condition. Clean and replace if necessary.
Clean and replace if necessary.
Check and adjust when engine is cold.
The spark plug is important
engine components, which
should be checked
periodically.
1. Unscrew but unloosen
the screw
u
, and take
off the left exterior cover
v
.
2. Noise suppressor cap
w
assy
, install spark
plug wrench box
the spark plug
appropriately.
3. Insert the handlebar
in to the tool and turn it
counterclockwise to
remove the spark plug.
4. Check for discoloration
and remove the carbon.
The porcelain insulator
around the center
electrode of spark plug
should be a
medium-to-light tan color.
5. Check the spark plug
type and gap
Maintenance chart
WARNING
maintenance work.
Use only franchised dealer specified genuine parts for
replacement. Ask an authorized franchised dealer for further
attention.
However, the spark plug should be tightened to
the specified torque as soon as possible.
7. Install the spark plug cap and spark plug cover.
x
on
CARBURETOR ADJUSTMENT
The carburetor is a vital part of the engine. Adjusting
y
should be left to a dealer with the professional knowledge,
specialized date, and equipment to do so properly.
CLEAN FUEL FILTER
9
Stop the engine before starting
Pre-operation
6 months
check (daily)
or 100 Hr
(1)
(2)
6. Install the spark plug.
TIP:
If a torque wrench is not
available when installing
a spark plug, a good
estimate of the correct
torque is 1/4-1/2 turn
past finger tight.
1. Unscrew but unloosen
the screw
off the left exterior
cover
v
2. Drain the fuel in the fuel
tank. Hold the tube clip
toward downward and
pull out the fuel tube
which connect on the fuel
tank, then disassemble
fuel filter.
12 months
or 300 Hr
T
T
T
u
, and take
.
w
x
Publicidad
