Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
ENGINE OIL REPLACEMENT
NOTICE
• Do not tilt the generator when adding
engine oil. This could result in overfilling
and damage to the engine. Don't make
foreign body fail into engine.
• Oil and gasoline could pollute
the environment, don't throw it in
the trash or pour it on the ground.
y
3. Put the fuel filter
noncombustible or higher
flash point solvent and
clean it.
4. Assemble fuel filter
z
to the main jet
on
the fuel tank, then
assemble fuel tube
to main jet on the fuel
tank and install tube clip.
Avoid draining the engine oil
immediately after stopping
the engine. The oil is hot and
should be handled with care
to avoid burns.
1. Place the generator on a
level surface and warm
up the engine for several
minutes.
2. Unscrew but unloosen
the screw i and take off
the sight glass of engine
v
oil
.
3. Lift and incline
the machine; take off
w
the end cap
at
the bottom plate of
machine.
4. Remove the oil filler
x
cap
.
5. Place an oil pan under
the engine, remove
z
the oil drain bolt
.
drain the oil from
the oil tank.
6. Check oil filler cap
x
O-ring
y
. oil drain
z
bolt
, oil filler cap
{
packing
.
Replace immediately
new one if it damages.
7. Assemble oil drain bolt
and oil filler cap packing.
8. Add oil till to a suitable
level, tighten oil
filler cap.
9. Assembly the end cap at
the bottom of mechine.
10. Assembly the sight
glass of engine oil.
into
.
Muffler screen
WARNING
after the engine has been run. Avoid touching
the engine and muffler while they are still hot with
any part of your body or clothing during inspection
or repair.
10
1. Unscrew nut unloosen
the screw
off the left exterior
v
cover
2. Remove the air filter
cover and foam element
w
.
3. Wash the foam element
in solvent and dry it.
4. add oil for the foam
element and squeeze
out excess oil. the foam
element should be wet
but not dripping, avoid
be damage.
5. Insert the foam element
into the air filter case.
TIP:
Be sure the foam
element sealing surface
matcher the air filter so
there is no air leak.
The engine should never
run without the air filter;
excessive poisonous gas
will lead to piston and
cylinder wear.
6. Install the air filter case
cover in its original
position.
The engine and muffler will be very hot
1. Unscrew 6 bolts
take off shutter
2. Remove the muffler
screen
the bolt
3. Clean the carbon on
the muffler screen by
wire brush.
4. Check the muffler
screen and spark
arrester, replace
if it damage.
5. Install spark arrester.
u
, and take
.
u
, and
v
.
w
, and remove
x
.
Publicidad
