Publicidad
Fault
Cycle does not start. Real
Time delay" is indicated in
the display field.
Clock cannot be set.
"Set clock:" text remains in
the display field even
though the Menu button
has been pressed.
No time displayed.
End time cannot be
End time cannot be
selected.
selected.
Spin speed cannot be
selected.
Child lock cannot be
selected.
Detergent residue in the
detergent dispenser.
Water does not enter the
machine or detergent is not
washed away.
"Check water faucet!"
"Check water faucet!"
indicated in the display
field.
Water cannot be seen in
drum.
Washing solution has not
drained completely. "Suds
or blocked pump?"
indicated in the display
field.
Water is flowing out from
Water is flowing out from
underneath the machine.
underneath the machine.
Suds coming out of the
detergent dispenser.
Repeated spinning.
The laundry was not spun.
(Laundry is still wet).
30
Possible cause
End time selected and activated.
Cycle has already started; when a cycle has started, the
clock cannot be set.
The setting has switched from hours to minutes; both
selection points have the same text.
Time not set.
Time not set.
Cycle has already started; when a cycle has started, the
end time can no longer be selected.
Spinning is already in progress; during spin cycle the
speed cannot be changed.
The cycle has already started.
Detergent was damp or lumpy.
Water faucet not turned on.
Supply hose kinked or pinched.
Strainers in supply hose clogged.
Aquastop
Hose safety feature activated.
Aquastop
is triggered
Water pressure too low.
This is not a fault.
The water level is below the visible part of the drum.
Suds
Pump is blocked
The thread of the supply hose is not tight.
Leak in the drain hose.
Too much soap or non-HE soap used, pump could not
remove suds.
This is not a fault.
The unbalanced load detection system is attempting to
balance the load through repeated spins.
Load size too small.
Get other manuals https://www.bkmanuals.com
Action
None. Appliance starts automatically.
Wait until cycle ends.
None.
Set time (see Page 18).
Set time (see Page 18).
Before starting the cycle, select and start the desired end
time (see Page 24).
Select speed before spinning.
Child lock can be selected in pause mode.
Clean and dry the detergent dispenser (see Page 27).
Use the cap of the detergent bottle to measure liquid
detergents.
Turn on water faucet.
Cycle continues.
Eliminate the cause.
Clean the water inlet strainers (see Page 27).
Check for safety indicator (see page 13). If red, replace
hose.
Close water faucet and investigate leak.
Eliminate the cause.
Use less detergent for future wash loads. Detergents
specifically designed for your High Efficiency washer
produce fewer suds and will include the letters HE" on
the packaging.
Clean the water drainage pipe and/or drain hose.
Tighten the thread.
Replace the drain hose.
Mix 1 tablespoon of fabric softener with 1 pt (½ litre) of
water and pour into the detergent compartment (do not do
this with outdoor (waterproof) fabric)
Use less detergent for future wash loads. Detergents
specifically designed for your High Efficiency washer
produce fewer suds and will include the letters HE" on
the packaging (look for the HE" symbol).
Always load the drum with several large and small items
together.
Add more laundry.
Publicidad
