Peg-Perego Viaggio 0+1 Convertibile Instrucciones De Uso página 23

IMPORTANT: the belts should be loose enough
for your finger to fit between the belt and the
child's chest.
19• To slacken the safety belts, push the button in the
middle of the child seat and pull the belts towards you
at the same time.
IMPORTANT: hold the safety belts under the
shoulder pads and pull, as shown in the picture.
20• The car seat has a booster cushion that must be used
only for very young children. Remove it when the child
is older.
• To remove the booster cushion, unfasten the safety
belts, remove them from the booster and remove the
leg-rest through the slot in the booster.
IMPORTANT: the booster cushion must be
removed when the Viaggio 0+1 Convertible is used
as a Group 1 car seat.
How to adjust the height of the head
rest
The head rest must be adjusted to match the child's
height. There are 7 positions.
21• To change from a lower position to a higher one:
pull the strap in the upper central part of the headrest
upwards. The headrest will move at the same time.
To change from a higher position to a lower one:
pull the strap in the upper central part of the headrest
upwards and, at the same time, push the headrest
down to the desired position.
When you have finished, try moving the headrest
to check it is properly attached.
22• WARNING: do not use the child seat as Group 0+
without first extracting the casing, as shown in point 1
A-B (Fig.A).
WARNING: do not use the child seat as Group 0+
without first reclining the backrest, as shown in point
1C (Fig.B).
2 3• Group 0+ mode: the safety belts are correctly
positioned if the child's shoulders are just above the
strap holes of the safety belts.
24• IMPORTANT: the safety belts should not be too
far above or below the child's shoulders.
25• WARNING: do not use the child seat as Group 1
with the casing extracted.
2 6• Group 1 mode: the safety belts are correctly
positioned if the child's shoulders are just below the
strap holes of the safety belts.
27• IMPORTANT: the safety belts should not be too
far above or below the child's shoulders.
28• IMPORTANT: The Viaggio 0+1 Convertible car seat
can be reclined in 5 different positions only when it is
used as a Group 1 seat.
To recline the seat, press the lever under the seat (fig.
A) and pull it towards you to the desired position (fig.
B).
How to remove the lining
To remove the lining of the Viaggio 0+1 Convertibile
child seat:
• Remove the head hugger, where present (point 20).
• Unfasten the safety straps (point 13).
• Open the rear cover.
29• Unfasten the straps from the rear support.
30• remove the safety belts from the front (fig. A) and
remove the shoulder pads, which have Velcro straps for
easy unfastening (fig. B).
31• unthread the strap through the slot (fig. C) and then
remove the head rest cover from the top (fig. D);
32• Below the frame, unfasten the leg divider (fig. E) and
remove the strap from the fabric leg divider (fig. F).
33• Slip the strap out through the slit in the fabric and
remove the lining, as shown in the figure.
Maintenance of the padding
Brush the fabric parts to remove dust.
• Before putting the cover in the washing machine
remove the foam rubber cushion from the booster seat
from the back.
• Machine wash at a maximum of 30°C with a delicate
wash setting and short spin cycle.
• Do not use chlorine bleach.
• Do not iron.
• Do not dry clean.
Do not remove stains with solvents.
23