Publicidad
Idiomas disponibles
Idiomas disponibles
48
www.electrolux.com
Problem
DEMO appears on the dis‐
play.
A
or
shown instead of numbers
on the temperature dis‐
play.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The FastFreeze function is
switched on.
The FastCool function is
switched on.
There is no cold air circula‐
tion in the appliance.
The appliance is in the
demonstration mode.
Temperature sensor prob‐
or
symbol is
lem.
Solution
Let the food products tem‐
perature decrease to room
temperature before stor‐
age.
Store less food products at
the same time.
Open the door only if nec‐
essary.
Refer to "FastFreeze func‐
tion" section.
Refer to "FastCool func‐
tion" section.
Make sure that there is
cold air circulation in the
appliance. Refer to "Hints
and tips" chapter.
To exit the demonstration
mode, press and hold the
OK button for approximate‐
ly 10 seconds until you
hear a long sound and the
display turns off for a short
time.
Contact the nearest Au‐
thorized Service Centre
(the cooling system will
continue to keep food
products cold, but temper‐
ature adjustment will not
be possible).
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to installation instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Publicidad
