Publicidad
Idiomas disponibles
Idiomas disponibles
11. Hold up the end of the guide bar and tighten the
bar nuts with the combination wrench.
•
Examine the chain tension frequently after
you assemble a new saw chain and until the
saw chain has been run-in.
•
Examine the chain tension regularly. Correct
chain tension results in good cutting
performance and a long life.
To reset the chain brake
If the clutch cover is removed accidentally while the
chain brake is locked, the chain brake must be
unlocked so the clutch cover can be assembled
without binding to the clutch drum.
CAUTION: The chain brake spring is
under tension. Use care when resetting
the chain brake.
Note: Do not hold the brake band while attempting to
reset it.
WARNING: Read and understand the
safety chapter before you operate the
product.
654 - 005 - 21.10.2019
1. Align the notches on the bar tool so that they fit
over the brake rotating link.
2. To reset the brake, rotate the link clockwise until
it stops. The front link will be in its downward
rotated position when the chain brake is
unlocked.
Operation
To use fuel
CAUTION: This product has a two-cycle
engine. Use a mixture of gasoline and
two-cycle engine oil. Make sure to use
the correct quantity of oil in the mixture.
Incorrect ratio of gasoline and oil can
cause damage to the engine.
11
Publicidad
