Publicidad
Idiomas disponibles
Idiomas disponibles
Total
120V
(0 - 7,6m)
Ampere ratting
More than -
Not more than
0 - 6
6 -10
10 - 12
12 - 16
8) INSTRUCTIONS FOR USE
- Always observe the safety instructions and applicable regulations.
- Use only one hand to hold the tool, do not place your other hand over the air vents Prior to
operation :
- Mount the correct accessory for the application.
- Set the desired air temperature.
8.1 Switching on and o
To switch the tool on, set the on/o switch to position I / Il / Ill. Some smoke may be emitted
after switching on; this does not indicate a problem.
To switch the tool o , adjust the lowest temperature to cool o , then set the on/o switch to
position 0. Let the tool cool down before moving or storing it.
8.2 Temperature setting.
Turn ON/OFF switch to l/ Il / Ill, depending on temperature you need. The heat gun will start
to buzz. Now you can increase or decrease the outlet temperature gradually by turning the
adjust knob.
Turn anti-clock wise to decrease, clock wise to increase the temperature. More LED lights turn
on when temperature increases.
Minimum gage for cordsets volts
length of cord in feet
0-25
26 -50
(7,6 - 15,2m)
American wire gage
18
16
18
16
16
16
14
12
3 YEARS
51 -100
(15,2 - 30,4m)
16
14
14
Not recommended
L I M I T E D WA R R A N T Y
101 - 150
(30,4 - 45,7m)
14
12
12
6
Publicidad
