Installation Instructions - Teka TMW 18 HG Manual De Instrucciones

EN

Installation instructions

Use the "open" button to open the door and
remove all packaging materials. Then clean the
inside and the accessories with a damp cloth and
dry them. Do not use abrasive or strong-smelling
products.
Ensure that the following parts are in good
condition:
Door and hinges
Front of the microwave
Inner and outer surfaces of the appliance
DO NOT USE THE APPLIANCE if you notice any
kind of defect in the aforementioned parts. If this
occurs, contact the Technical Support Service.
Place the appliance on a stable, flat surface.
Fit the motor coupling in the centre of the
microwave cavity and place the turntable support
and the turntable plate on top until it clicks into
position. Whenever the microwave is used, both
the rotating plate and the respective base must be
inside the oven and correctly positioned. The
rotating plate turns clockwise and anti-clockwise.
Warning! The microwave oven may be wrapped
in a protective film. Before switching it on for the
first time, carefully remove this film, starting at the
underside.
29
In order to ensure proper ventilation for the
appliance, install the microwave in a kitchen
unit with an opening on the top (see attached
sheets).
Warning: after installing the microwave, it is
necessary to guarantee
electrical socket.
During installation, ensure that the power
cable does not come into contact with the
back of the appliance, because the high
temperatures may damage the cable.
If you are installing a microwave and a
conventional oven in the same column, the
microwave must not be placed under the oven,
because of the formation of condensation.
The appliance must not be placed in the vicinity of
heating elements, radios or television sets.
The appliance is equipped with a power cable and
a plug for single phase current.
WARNING: THE MICROWAVE MUST ONLY BE
CONNECTED TO GROUNDED ELECTRICAL
SOCKETS.
In case of fault, the manufacturer and the seller
will not accept any responsibility if the installation
instructions have not been properly followed.
access to the