Glacial Hidro Serie Manual De Operación página 22

English
Verify the electrical diagram corresponding to your appliance in the decal
attached to the back of it.
If the power cord is damaged, it must be replaced by the manufacturer, its
service agent or certifi ed personnel.
INSTALLATION INSTRUCTIONS
Location Location
It is recommended that the back and sides of the appliance be separated
by at least 12 cm from the wall, respectively, to allow air fl ow to the com-
pressor and condenser.
Place your appliance on a level surface. Once installed, check that it is
level.
• Remove the outer and inner packaging.
• Place your appliance on a fl oor that is strong enough to support the
dispenser when fully loaded.
• Locate the appliance away from direct sunlight and external heat
sources such as: stoves, heaters, grills, etc. Direct sunlight can
aff ect the acrylic coating and heat sources can increase electrical
consumption.
• Extremely low ambient temperatures can also aff ect the performan-
ce and operating consumption of the appliance.
• Allow a 12 cm gap between the unit and the walls to allow adequate
airfl ow to the unit's condenser and compressor.
• This appliance is not recommended for outdoor use.
• Keep the appliance free of dust or dirt.
• Keep spare bottles away from excessive heat and sun light.
Página 22 de 27