Publicidad
Idiomas disponibles
Idiomas disponibles
English
•
Fill the tank with tap water up to its maximum capacity and wait 5
minutes for the water to settle.
•
Open the hot water valve until water comes out. Note: Some models
have a child safety key, so it must be slid before the hot water valve
can be opened.
•
Connect the appliance for 50 minutes to start the fi rst cycle of
operation. This will bring both hot and cold water up to operating
temperature.
•
Disconnect the appliance from the current. Proceed to drain the
valves or faucets one at a time until no water comes out. Note: to
facilitate the operation use a large container or bucket).
•
Then, drain the rest of the water from the line by opening the drain
cap located on the back of the appliance.
•
Once all the water has been drained from the appliance, proceed to
close the rear drain cap.
•
Remove the cap from your bottle (20 L or 5 gal.) and wipe the neck
of the bottle with a clean cloth.
•
Place the water bottle in the appliance's water inlet and let the water
stand for about a minute.
•
Press or turn on faucets to make sure water is fl owing properly.
•
Reconnect the appliance to power.
•
Now you are ready to use the appliance.
NOTE: Your appliance has been cleaned and sanitized before leaving
the factory, but in the event of a taste problem, add two tablespoons of
baking soda and tap water. Refi ll the tank and repeat the basic ope-
rations described above, except that the hot water function has to be
turned off to avoid leaving residues in the hot water tank.
IMPORTANT: If you do not plan to use the hot water function
for more than 3 days, it is recommended to turn off the hot
water function.
Página 24 de 27
Publicidad
