Blackmagic Design HyperDeck Extreme 4K HDR Manual De Instrucciones página 1043

Idiomas disponibles

The "play on startup command" instructs the deck on what action to take on startup. By default, the deck will

not play. Use the "enable" command to start playback after each power up.

play on startup: enable {"true" , "false"}↵

By default, the unit will play back all clips on startup. Use the "single clip" command to override:

play on startup: single clip: {"true" , "false"}↵

The "play option" command queries the output frame for when playback stops:

play option↵

By default, the deck will display the last frame when playback stops. To override this behaviour, the "stop

mode" parameter can be used:

play option: stop mode: {"lastframe" , "nextframe" , "black"}↵

Stopping deck operation

The "stop" command instructs the deck to stop the current playback or capture:

Changing timeline position

The "goto" command instructs the deck to switch to playback mode and change its position within the timeline.

To go to the start of a specific clip:

goto: clip id: {Clip ID}↵

To move forward/back {count} clips from the current clip on the current timeline:

goto: clip id: +/-{count}↵

Note that if the resultant clip id goes beyond the first or last clip on timeline, it will be clamp at the first or last clip.

To go to the start or end of the current clip:

goto: clip: {"start" , "end"}↵

To go to the start of the first clip or the end of the last clip:

goto: timeline: {"start" , "end"}↵

To go to a specified timecode:

goto: timecode: {timecode}↵

To move forward or back a specified duration in timecode:

goto: timecode: {"+" , "-"}{duration in timecode}↵

To specify between slot 1 and slot 2:

goto: slot id: {Slot ID}↵

Note that only one parameter/value pair is allowed for each goto command.

Enumerating supported commands and parameters

The "commands" command returns the supported commands:

The command list is returned in a computer readable XML format:

212 commands:

<command name="..."><parameter name="..."/>...</command>↵

</commands>↵

More XML tokens and parameters may be added in later releases.

Developer Information