Publicidad
Idiomas disponibles
Idiomas disponibles
Translation of the original instructions
STARTING
Assembly
Choose the required tool (one of the coiled wires, the braided wire or the straight wire) and fit it on the inductor. To
do so, insert the two rods of the selected tool and insert them into the holes intended for this purpose, then screw
the tightening wheels (fig.2). To unscrew a tightening wheel, it is possible to use a spanner/wrench size 12. Warning :
never use a spanner/wrench to screw the tightening wheel as it may get damaged.
Heating activation
Start the product by pressing the ON/OFF button.
Press the inductor button to activate the heating. Keep
pressing the button to keep the heating active.
Protections
The product is equipped with protections :
Thermal protection
Overcurrent protection
Trigger defect
RECOMMENDATIONS
The coiled inductor is designed for unjamming. it heats metal pieces or parts via induction to unblock and remove them
easily. Circle the piece using the appropriate accessory (coiled, braided, straight), then heat the inductor, that will be
used to heat the metal piece. Once the piece starts to be coloured in red, stop the heating and remove it using the right
tool (clamp, spatter/wrench...) then remove it.
ACCESSORIES
The accessories provided are consumables. These must be replaced when they are damaged.
Damaged consumables (burnt sleeves, etc.) can cause serious damage to the product.
Spirals must be made up of at least 3 turns in order not to damage the product.
In order to be able to work on parts with multiple shapes, 5 or 12 types of accessories accompany the inductor
(According to the version).
It works in the same way as coils and braided wire. Its shape must be adjusted to fit the metal piece's shape and if
possible, circle around the piece several time for maximum efficiency.
1
POWERDUCTION 10R
The orange LED is lit when the product is in thermal protection. The product trigger
is inactive during this time. Wait for the orange LED to go out before restarting the
heating process.
In case of overcurrent, the orange LED flashes. The product trigger becomes inactive.
Restart the product to clear the fault and restart heating.
On power-up, if the Powerduction detects a fault on the trigger, the orange LED lights
up. Disconnect the faulty trigger and replace it. Then restart the heater.
2
The green LED lights up.
The green LED flashes green as long as the heating is
active.
3
fig.2
EN
1- Button
2- Tightening wheels
3- Spirale
13
Publicidad
