Publicidad
Idiomas disponibles
Idiomas disponibles
Translation of the original instructions
OPTIONAL ACCESSORIES
Powerduction 10R
3 coiled wire (Ø 18, 24, 30 mm)
Standard tool, already shaped for a fast and effective ope-
ration. The coil shape enable optimises the concentration
of the magnetic fields in its centre, which guarantees a
powerful and effective induction heating. The glass fiber
circle can electrically insulate the coils as well as the ele-
ment to heat. The coil is used in the following way : po-
sition it at the centre then press the inductor's button to
start the heating.
Flexible braided wire
The braid is designed for pieces that cannot be heated with the coil (parts with a bigger diameter) :
Ex. an exhaust pipe or a wheel hub
The braid can be enrolled around the metal piece.
To obtain a better result, circle 3 times around the metal piece and make sure that the coils are bonded together.
Press the inductor's button to start the charge.
Straight rigid wire
The straight rigid wire is designed to suit any of the user's needs. It can be :
- adjusted to the shape of a specific part/piece.
- adjusted to a piece that is too big for the coils.
- copy the shape of an existing coil if the latter is damaged.
RECOMMENDATIONS
• When heating the coils for the first time, some smoke will be released.
• Avoid heating for more than 30s, the coils will heat excessively and suffer premature damages.
• It is not necessary to come in contact with the bolt to heat it.
• The coil's protective fabric is fragile, it is glass fabric : make sure to store the coils in such a way that they do not
get damaged.
The coils heat very fast. After use, is is recommended to let them cool down before storing them. Ma-
nipulate with gloves to prevent burns or itches caused by the glass fabric.
Do not place a finger or any limb inside or close to the coil when the machine is switched on. Magnetic
fields should be considered.
14
POWERDUCTION 10R
Heating efficiency :
To achieve maximum heating power efficiency, the coil must be adapted to the
workpiece.
066601
Adhesive-removal inductor
079472
Ferrite inductor for all types of ferrous metals.
079489
Replacement ferrite
Powerduction 10R PRO
10 coiled wire (Ø 18, 21, 24, 27, 30 mm SIDE) and
(Ø 18, 21, 24, 27, 30 mm FRONT)
Standard tool, already shaped for a fast and effective ope-
ration. The coil shape enable optimises the concentration
of the magnetic fields in its centre, which guarantees a
powerful and effective induction heating. The glass fiber
circle can electrically insulate the coils as well as the ele-
ment to heat. The coil is used in the following way : po-
sition it at the centre then press the inductor's button to
start the heating.
EN
Publicidad
