WARNING
BE CAREFUL NOT TO PINCH, CRIMP, OR
DAMAGE THE CONTROL CABLE WHEN
INSTALLING THE HANDLE.
4
OPERATION
This section describes how to operate the product.
WARNING
CAREFULLY READ AND UNDERSTAND
THE SAFETY CHAPTER AND OPERATION
INSTRUCTIONS BEFORE YOU OPERATE THE
PRODUCT.
4.1
BEFORE USING THE PRODUCT
4.1.1
BATTERY CAPACITY INDICATOR
The product has LED lights to indicate the battery
level.
1.
After installing the batteries, the display will show
the current battery level.
L
R
2.
Please refer to the table for battery capacity.
Lights
Capacity
4 Green Lights
The battery is above 80% ca-
pacity
3 Green Lights
The battery is between 80%
and 60% capacity
2 Green Lights
The battery is between 60%
and 40% capacity
1 Green Light
The battery is between 40%
and 20% capacity
No Green Light.
The battery is less than 20%
capacity and requires charging
immediately
4.1.2
CONNECT THE BATTERY CHARGER
1.
Connect the battery charger to the proper voltage
and frequency that is specified on the rating plate.
English
L
TURBO
R
2.
Refer to the Battery Charger Operator Manual for
information about how to use the battery charger.
4.1.3
CHARGE THE BATTERY
Refer to the Battery Charger Operator Manual for
information about how to use the battery charger.
4.1.4
BATTERY INFORMATION
Refer to the Battery Operator Manual for information
about how to use the battery.
4.2
ADJUST THE HANDLEBAR POSITION
1.
Simultaneously pull the 2 handlebar latches to
release the handlebar lock.
2.
Lift the handlebar up until it locks into the
mounting holes. Adjust to the position that is best
suited to your height.
Note: Ensure that both handles are in the same
position.
4.3
SET THE CUTTING HEIGHT
This lawn mower has seven different cutting height
settings.
1.
Move the cutting height lever out and backward to
increase the cutting height.
9
EN