Create Wind Flowood Manual De Instrucciones página 12

WIRING CONNECTION
Make the connection between the receiver wires and the fan motor wires following the color
indications. Make sure the connection is tight.
Take ground
L
N
FAN SUSPENSION
1. Hang the motor housing on the mounting bracket. Rotate the fan so that the notch in the
ball engages the ridge of the mounting bracket.
2. Place the remote control receiver into the slot of the mounting bracket as shown in the
figure.
3. Drive two screws in the middle position into opposite holes until there is approximately
5mm between the screw head and the edge of the mounting plate. Don't forget to place
washers between the screw head and the mounting bracket.
4. Slide the canopy onto the mounting bracket and align the locking slots with the two in-
stalled screws.
5. Turn the finial and tighten the screws. Install the two remaining mounting screws into the
other two holes in the canopy and tighten securely.
6. Once the electrical installation has been checked and completed, push the canopy up-
wards until the ceiling support and all the connection cables are covered. Match the
screws by lining up the holes in the canopy with the side holes in the bracket.
E NGL I SH
12
L input
(black)
Command
receiver
from
Input N
distance
(white)
Ground (green/yellow)
DC L motor (gray)
DC L motor (pink)
DC L motor (red)